SolarRoofs.com Store Home Previous Page
Total: $0.00

Value System 2 has a 110 Volt circulator controlled by a Differential Controller with 2 sensors, built in re-circulation light freeze protection and dual Digital Temperature readouts. It is for use in areas with no freeze or very light freeze.

This system circulates potable water through the collectors and then returns the solar heated water into the stoarage tank. The standard configuration used a "Quick Connect" that replaces the drain at the bottom of the tank with a "coaxial" fitting.

This fitting allows the solar collector's feed and return line to share the same hole. Returning solar heated water goes through a center tube into the tank. The warmer solar heated water immediately rises and at the same time cool water is being sucked by the solar pump through the space around the hot return tube.

Click here for the System 2 Installation Manual

Click here for the System 2 Two Tank Diagram Page
Click here for the System 2 Owner's Manual

Temperate System 2 Features:

110 Volt Pump with Digital Readout Control with line cords

Light-weight, easy to install collector with all copper high performance absorbers

Complete "Easy Mount" rail system

All solar Loop Parts and Fittings Included except copper tubing

No soldering required for the entire solar loop

"Quick Connect" to bottom of tank or optional Top Connects available

Choice of "Stacked" or "Side by Side" collector layouts

Choice of 2 Standard and 24 optional Collector Trim Colors

A choice of options to make the system just right for you

Temperate System 2 Parts List:

10 square foot solar thermal collector(s), 20" wide x 6' long

Rail flush mounting kit with lags

110 Volt Pump with line cord

Differential Controller with line cord and two sensors (with built-in Re-circulation freeze protection)

Compression Unions, Lag screws, Washers, Tec screws

6' sample section of high temperature insulation

"Quick Connect" Kit for existing or added water heater with shut off and drain valve

Floating ball check valve ("Bottom Connect" is standard, "Top Connect" (TC02) is available at a $60 extra charge)

Floating ball chack valve ("Bottom Connect" is standard, "Top Connect" (TC02) is available at a $60 extra charge)

Solar Loop Pressure Relief Valve (PRV)

Installation & Owner's Manuals

NOT Supplied:

Storage Tank

50' roll of copper tubing (Available below)

Water side plumbing

Tempering Valve (Available below)

Insulation (Available Below)

Please Note: Some of the above photos are System Options, and are NOT included in the system.
Below are photos of a Four Top Port 80 or 120 gallon tank with an open loop configuration, OPTIONAL if you already have or plan to have a 4 Port Top Tank. Photos may show parts that are NOT included in this system.
Click to enlarge - Four Port Top Tank
Click to enlarge - Four Port Top Tank
Click to enlarge - Four Port Top Tank
Click to enlarge - Four Port Top Tank
Click to enlarge - Four Port Top Tank
Click to enlarge - Four Port Top Tank
Temperate System 2
Model #
Price
(1) 10-01 (10 ft2) – Cabin / Boat / Motor-Home
$1,095.00
(2) 10-01 (20 ft2) for 1 to 2 people
$1,395.00
(3) 10-01 (30 ft2) for 3 to 4 people
$1,645.00
(4) 10-01 (40 ft2) for 3 to 5 people
$1,895.00
(5) 10-01 (50 ft2) for 4 to 6 people
$2,145.00
(6) 10-01 (60 ft2) for 5 to 7 people
$2,395.00
(8) 10-01 (80 ft2) for 6 to 10 people, SSCI Only 
$2,895.00
Collector Configuration Options
Standard Color: Musket Brown (a dark architectural brown)
$0.00
Standard Color Option: Musket Brown (a dark architectural brown)
$0.00
Optional Trim Colors: Choose from one of 24 Optional Colors
$85.00
Stacked Collector Array Installation Kit (w/ system purchase)
$0.00
Side by Side Collector Array Installation Kit (w/ system purchase)
$0.00
Substitute One 20-01 Collector for every two 10-01 collectors
$0.00
Temperate System 2 Options
50 foot roll of 3/8" ID, 1/2" OD soft copper tubing
$98.00
Tempering Valve (3/4” C x C x C)
$98.00
Solar Top Connect without Tempering Valve
$60.00
Solar Top Connect with Tempering Valve
$245.00
Top Tempering Valve Assembly
$185.00
180ºF High Temperature snap switch (place on cold in)
$22.00
Quad Flow Diverter (with 4 - ¾” solder connections for duel tanks)
$84.00
Digital Twin Temperature Readout
$78.00
250º F 2" Temperature Gauge with ½” MPT fitting
$38.00
Insulation:  High Temperature Solid 1/2" wall for 1/2" tube X 6' long
$9.75
Insulation:  High Temperature Solid 1/2" wall for 3/4" tube X 6' long
$13.00
Light Freeze Valve Option(s)
For Standard Stacked mounting system
$118.00
For Optional SSC1 Side by Side mounting system
$126.00
5840 Gibbons Dr. Suite H, Carmichael, CA 95608
Toll Free: (888) 801-9060 Fax: (916) 481-7203

Click here to e-mail us!
SolarRoofs.com Home | Store Home | No Freeze | Light Freeze | Hard Freeze | Collectors | Parts
Shipping Info. | Shipping & Return Policy | How Our Shopping Cart Works | Payment Methods
Our Most Popular Systems

Top of Page
 
All prices & specifications are subject to change without notification. Shipping cost may not
be included, unless stated. Other custom collector combinations available upon request.