Premium System 3 is 100% Run by the Sun! It has a 12 Volt circulator that is powered by a Photovoltaic Panel, it is for use in areas with no freeze or very light freeze. This system circulates potable water through the collectors and then returns the solar heated water into the storage tank. The standard configuration used a "Quick Connect" that replaces the drain at the bottom of the tank with a  "coaxail"  fitting.  This fitting allows the solar collector's feed and return line to share the same hole.

Returning solar heated water goes through a center tube into the tank. The warmer solar heated water immediately rises and at the same time cool water is being sucked by the solar pump  through the space around the hot return tube. This system is so complete, it even includes FREE! 36' of High Temperature insulation!

• 10 or 20 sq. ft solar thermal collector(s), 20” wide x 6’ or 12’ long

• Rail flush mounting kit with lags

• System dependent 12 volt Laing, ElSid or March circulation pump

• 5, 10 or 20 watt PV panel with 25’ of wire

• 50’ roll of ½” OD soft copper

• Compression unions

• Lag screws

• Washers

• Tec screws

• 36’ of 1/2" wall high temp insulation 

•  “Quick Connect” Kit for existing or added water heater with shut off and drain valves

• Floating ball check valve (“Bottom Connect” is standard, “Top Connect” (TC04) is available at (New Prices) extra charge)

• Solar Loop Pressure Relief Valve (PRV) with splash guard

• Air vent with pre-soldered assembly

• Temperature gauges

• Tempering valve (20 s/f and above) 

• Special OG-300 labeling

• Installation and Owner’s Manuals.